How would you title video where you talk about reasons why you’ve stopped using Arch?

Eye pulley angry

It’s cool but it’s just more hassle than it’s worth at the moment.

We’re waiting for you… In the test chamberrrr

seems like that helped, thanks!

Seems like that has worked, thanks a lot!

I already have overlay and game recording disabled. I’ll give those launch options a go, will let you know if it helped. Thanks.

I was on 6.13.x kernel, now 6.14.x and yes, also went forn MESA 24.x.x to 25.x.x which is default for Fedora 42 now. Refresh rate is fine. Not sure what I should be looking for in the Steam logs. Game is not crashing and otherwise seems to be running fine unless I use any kind of input when this starts to happen.

Are you also on GNOME or KDE? Because I’m thinking of reinstalling to KDE and try if it happens there as well but to be honest, I much better like GNOME experience and I would have to setup everything again…

Yeah, it’s just trough Steam.

I’ve just finished installation and setup… now just downloading some games and I’m ready to play the new BG3 patch.

"This goes against my distro choice and I need validation to feel superior! "

Reading the comments, it’s obvious they either didn’t watch the video and those that did, missed the point of what he was saying and got butthurt instead… Internet comments on a nutshell

It’s basically this https://youtu.be/gGi3RdN0c1c

If its after then depends on the colour of the ending

What if we just want to make you think that?

Exactly as Aizen planned

I also had it start on boot but I never could minimize it to be non-intrusive and from what I’ve researched it’s apparently very known issue in GNOME.

I don’t have this issue with LACT.

I’m sorry but I don’t believe you. Maybe you just misunderstand what I’ve meant.

If you minimize it and press Super key, is it shown or it’s completely gone?

Yes I do otherwise I wouldn’t be able to OC.

I have to enable it with script after every Kernel update.

What I’m doing goes beyond typical GPU overclocking otherwise there’s no need to do what I’m trying to achieve here.

If you had to compare it to Wimdows it’s basically MPT OC.

Thanks a lot. I will look into this.

Reason why I use chmod is because I cant for the life of me figure out why I can’t just use sudo. Even when I set environment variable for the upp.py it refuses to run it. Even when I directly want to run it via sudo it refuses, I can only run it without sudo for whatever reason… but to overwrite pp_table I need sudo privileges and I’ve been only able to get around with chmod.

Also I’ve tried to make a script that I will just run and will execute the commands… but I get immediately hard lock and black screen and I need to do hard reset. Same when I try to copy and overwrite the pp_table with sudo priviledges with a pre-modified pp_table.

So I’m kinda hesitant to now run the commands on runtime, it’s possible it will hardlock during boot. I will give it more though tommorrow.

edit:

I just found out how to write the pp_table into VBIOS so I will try flashing modified VBIOS on the card and hope it will work. I’ll leave that for tomorrow though.