Anycubic is a fine company they just have shitty consistency. I’ve owned a kobra pro, three kobra neos, three kobra2 neos and a kobra3 with the ace. I’ve loved all of them but the k3. They’re trying to get too much speed from a bed slinger in my opinion. It may do okay printing light parts with enough surface area on the bed to not be thrown off but when you’re printing functional stuff at 99 infill it has a tendency to launch shit mid print. Perhaps they’ve fixed all that with the newer models/iterations but It was disappointing enough I went back to my kobra2 neos… I’d like to hear about your experience with the X when you get it assembled and printing. I can’t decide whether I should take a chance on another printer or hoard k2 neo parts before that get difficult to locate.
Anycubic is a fine company they just have shitty consistency. I’ve owned a kobra pro, three kobra neos, three kobra2 neos and a kobra3 with the ace. I’ve loved all of them but the k3. They’re trying to get too much speed from a bed slinger in my opinion. It may do okay printing light parts with enough surface area on the bed to not be thrown off but when you’re printing functional stuff at 99 infill it has a tendency to launch shit mid print. Perhaps they’ve fixed all that with the newer models/iterations but It was disappointing enough I went back to my kobra2 neos… I’d like to hear about your experience with the X when you get it assembled and printing. I can’t decide whether I should take a chance on another printer or hoard k2 neo parts before that get difficult to locate.